By: Shane Harrington, BMP Forester (Ret.), Texas Forest
Service
Q: I heard the Texas Forest Service recently completed
another round of best management practices (BMP) implementation
monitoring. How well are we implementing
BMPs on silvicultural operations and are there any areas that still need
improvement?
A: Last time I addressed the BMP implementation rates for
each landowner category as well as the overall BMP implementation rate for the
Round 6 BMP Implementation Report. This
month I would like to address the areas in which we had improvements and some
areas that still need improvement.
There were three areas in
which we saw major improvements from previous rounds. The three areas where we saw major
improvements were the increase in the rate of BMP implementation on family
forest lands, a higher overall rate of BMP implementation on permanent and
temporary roads, and a decrease in the incidences of significant risks to water
quality. As stated in last month’s
article, Family Forest Owners achieved an all time high with an 88.7% BMP
implementation rate. This means that
landowners are becoming more familiar and educated about BMPs.
The increase in
implementation on permanent and temporary roads can be attributed to roads
being properly placed and water control structures (i.e. waterbars, wing
ditches) being used. This is a major
improvement because 90% of all sedimentation that occurs on a tract comes
directly from runoff from the roads. By
properly placing roads and using water control structures, sedimentation is
less likely to occur.
The last area, which can be
directly related to the previous two improvements, is the decrease in the
number of significant risks to water quality.
A significant risk to water quality exists if, during a normal rainfall,
sediment is likely to be delivered to a permanent water body. A permanent water body is defined as any blue
line stream (i.e. perennial and intermittent streams) or lake. Significant
risks to water quality can be avoided by making sure that roads are properly
stabilized, stream crossings are restored and stabilized, and that there is an
adequate SMZ.
There were two major
deficiencies noted during the evaluations: failure to restore and stabilize
stream crossings on temporary roads and failure to remove logging debris from
streams. Once a stream crossing is no
longer needed, the crossing should always be removed immediately and the
approaches and stream banks should be stabilized and restored to prevent any
soil from moving into the stream. Care
should always be taken while operating near a stream or within an SMZ to ensure
that logging debris does not end up in the stream. Any logging debris should be removed immediately
from the stream to prevent blocking the natural water flow of the stream and to
prevent any sediment from entering the stream.
Overall a good job is being
done implementing and adhering to Texas BMP guidelines as shown by the 91.7%
BMP implementation rate for Round 6.
This is the highest BMP implementation rate that the Texas Forest
Service has ever seen. Hopefully in the future there will be a continued
improvement of the BMP implementation rate.
Remember that one way to continue to improve is to recognize the
importance of using BMPs to protect water quality by treating each site as if
it will be evaluated.
A copy of the Round 6
Voluntary Implementation of Forestry Best Management Practices in East Texas report can be obtained by visiting the Texas
Forest Service website at http://txforestservice.tamu.edu/water. For further information regarding the Round 6
BMP implementation report or BMPs in general please call me at (936) 639-8180.
* This article was published in the December 2005 issue of the Texas Logger
